TANDBERG TT1260 - Manual (Page 37)

Installing the Equipment
Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder Page 2-11
ST.TM.E10100.1
Table 2.5: Audio Decoding Pin-outs
Item Specification
Connector type 9-way, Female, D-type
Connector designations AUDIO 1
AUDIO 2
Pin-outs Pin 1 ¾ Digital audio +
Pin 2 ¾ Ground
Pin 3 ¾ Left +
Pin 4 ¾ Right +
Pin 5 ¾ Ground
Pin 6 ¾ Digital audio -
Pin 7 ¾ Ground
Pin 8 ¾ Left -
Pin 9 ¾ Right -
Nominal output impedance 50 W
Maximum data rate 3.072 Mbit/s
Output level +18dBm nominal clipping level. Selectable in range 12 to +24dBm.
Load impedance ³600 W balanced
Analogue Video Output
This BNC socket provides the standard definition (SD)
analogue output in the form of a composite video
output. The output standard is configured using the
Video Menu #3.1. The specification for these
connectors are given in Section B.5.1, Video Outputs.
CVBS 1/2
Table 2.6: Analogue Output Connector (2 Off)
Item Specification
Connector type BNC 75 W socket
Connector designation CVBS 1
CVBS 2
Pin-outs Centre
Shield Video output
Ground/Chassis
Digital Video Output
The serial digital video output is routed in 4:2:2
format to an SDI output at 270 Mb/s via two BNC
sockets. Video control is through the Video Menu
#3.1. The specification for these connectors are given
in Section B.5.1, Video Outputs.
SDI 1/2
Table 2.7: Digital Output Connector (2 Off)
Item Specification
Connector type BNC 75 W socket
Connector designation SDI 1
SDI 2
Pin-outs Centre
Shield Video output
Ground/Chassis