TANDBERG TT1260 - Manual (Page 108)

Technical Specification
Page B-16 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
Digital Video
These connectors are located on the motherboard of the TT1260 Base Unit
(TT1260/DIRBAS).
Table B.21: Digital Video Output Connectors
Item Specification
Safety status SELV
Connector type BNC, Female, 75 W
Connector designation CVBS 1
CVBS 2
Connector design SDI
Output standard (UK/EEC):
Output standard (USA):
ITU-R RECMN BT.656-3 Interfaces for Digital Component Video Signals in
525-Line and 625-Line Television Systems Operating at the 4:2:2 Level of
Recommendation ITU-R BT.601 (Part A)
Publication Date: 1995-00-00
ANSI/SMPTE 259M Television 10-Bit 4:2:2 Component and 4 fsc Composite
Digital Signals - Serial Digital Interface
Level C - 270 Mbit/s, 525/625 component (Section 10.2)
Date: 1997-09-25
Jitter Performance, Nominal SMPTE Recommended Practices RP 192 –1996 Jitter Measurement
Procedures in Bit-Serial Digital Interfaces
B.6.2 Audio Outputs
Analogue and Digital audio are output on two, 9-way, male, D-type
connectors, located on the motherboard of the TT1260 Base Unit
(TT1260/DIRBAS).
Table B.22: Analogue Audio Output Connector
Item Specification
Safety status SELV
Connector type 2 x 9-Way D-type
Connector designation AUDIO 1
AUDIO 2
Output level +18 dBm nominal clipping level.
Selectable in range 12 to +24 dBm.
Nominal output impedance 50 W
Load impedance ³600 W
Compressions layers MPEG-2 layer 1 and 2, linear audio and Dolby Digital (AC-3)
Sampling rates 32 kHz, 44.1 kHz and 48 kHz
Output formats Analogue, IEC958 CON, AES3 and IEC958 AC-3