TANDBERG TT1260 - Manual (Page 15)

Introduction
Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder Page 1-7
ST.TM.E10100.1
·
Conditional Access/Scrambling:
² Remote Authorisation System (RAS) version I
² EBU Basic Interoperable Scrambling System (BISS) Mode-E
² EBU Basic Interoperable Scrambling System (BISS) Mode-1
² VideoGuard Director
² TANDBERG Television Signal Protection
·
TANDBERG Director system:
² Over-air remote control is available if the TT1260 is used as part of
a TANDBERG Director system (Over-air software downloading,
Re-start, Tuning and Retuning etc.)
NOTES…
1. The TANDBERG Director system GUI counts the inputs from zero (i.e. 0, 1).
2. TANDBERG Director versions 4 and onward allow selection of the L-band (RF) input.
·
Remote Control:
² RS-232 or RS-485
² NCP Over-the-Air remote control via VideoGuard Director
² When the remote control is active, front panel control is disabled
but status information is still available (protocol is available from
TANDBERG Television Limited)
·
Clock/Calendar:
² Available to co-ordinate universal and local time
² Constantly updated when locked to a valid transport stream
· Transport Stream Demultiplexing:
² Maximum capability is 160 Mbit/s, depending on CA in use and
input front end
· Video Decoding:
² Maximum Video Demultiplexing capability of 50 Mbit/s
· Audio:
² Audio embedding in the digital video output
·
Vertical Blanking Interval (VBI) signalling support:
² World System Teletext (WST)
² Support for Closed Captions and VITS/ITS/VITC
² Inverted Teletext
² Video Programming System (VPS)/Programme Delivery Control
(PDC)
² Neilson Coding AMOL 1 and AMOL 2
² Vertical Interval Time Code (VITC)
² Video Index
² Video Test Pattern Generator
·
Error Data Handling (EDH):
² EDH is supported on the SDI (digital video) output
·
Frame Synchronisation of digital video output to analogue input