TANDBERG TT1260 - Manual (Page 107)

Technical Specification
Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder Page B-15
ST.TM.E10100.1
B.5.4 Frame Sync Connector
The Decoder can frame lock to an external video source. The frame
information is input as a composite synchronous signal, with or without
active video. The user can offset the sync to the video output by ±8 lines,
with a resolution of one pixel.
Lip sync error introduced by the Receiver is in the range –10ms to +30ms.
This implies audio frame skip and repeat.
It is possible to connect multiple Receivers to the same reference signal.
This input requires an external 75 W termination.
Table B.19: Frame Sync Connector
Item Specification
Connector type BNC, Female
Connector designation Frame Sync
Pin: Centre Analogue Black and Burst Input
Shield Ground/Chassis
Impedance 75 W
B.6 Output Specifications
B.6.1 Video Outputs
Analogue Composite Video
These connectors are located on the motherboard of the TT1260 Base Unit
(TT1260/DIRBAS).
Table B.20: Analogue Video Output Connectors
Item Specification
Safety status SELV
Connector type 2 x BNC Female socket 75 W
Connector designation SDI 1
SDI 2
Video standards PAL – I, B, G, D
PAL – N
Combination PAL - N
PAL - M
NTSC-M (with and without pedestal)
(set on Video Menu, #3.1)
Composite video level 800 mV pk-pk nominal ±10%
Composite video level adjustment 0.7 to 1.3 Vpk-pk