Toshiba Integrated High Definition LED Television 50L2200U User Manual
Page 48
48
Setting up your TV
Storing channels in memory (optional)
❖
You must set up the ANT/CABLE input source before
programming channels. See
.
❖
The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
❖
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
❖
Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source. If you have not already
done so, see
.
2
Press the MENU button and open the Setup menu.
3
Highlight Installation, and then press the ENTER button.
(Sample Illustration) Setup menu - Installation selection
NOTE