TDK GENESYS 750W HALF RACK - Manual (Page 35)

83-507-5002 Rev. B
27
CHAPTER 4 FRONT AND REAR PANEL CONTROLS AND CONNECTORS
4.1 INTRODUCTION
The Genesys
TM
Power Supply series has a full set of controls, indicators and connectors that al-
low the user to easily setup and operate the unit. Before starting to operate the unit, please read
the following Sections for explanation of the functions of the controls and connectors terminals.
-Section 4.2: Front Panel Controls and Indicators.
-Section 4.3: Rear Panel Connections and Controls.
4.2 FRONT PANEL CONTROLS AND INDICATORS
See Fig.4-1 to review the controls, indicators and meters located on the power supply front panel.
Table 4-1: Front Panel controls and indicators
Number Control/Indicator Description Section
1 VOLTAGE
control High resolution rotary encoder for adjusting the Out-
put Voltage. Also adjusts the OVP/UVL levels and
selects the Address 5.2.1
5.3.1
5.4.1
7.2.2
2 VOLTAGE
indicator Green LED, lights for constant-Voltage mode opera-
tion.
3 VOLTAGE
display 4 digit, 7-segment LED display. Normally displays
the Output Voltage. When the PREV button is
pressed, the display indicates the programmed set-
ting of the Output Voltage. When the OVP/UVL but-
ton is pressed, the Voltage display indicates the
OVP/UVL setting.
Fig.4-1: Front panel controls and indicators
VOLTAGE
ALARM FINE PREV/
OVP
UVL FOLD REM/LOC OUT
DC AMPS CURRENT DC VOLTS
POWER
1
14
17 18
19
2
15
16
3
13
10
4
11
5
12
9
6
7
8