Timex Global Trainer W260 - Manual (Page 7)

3
Status Bar
The status bar appears at the bottom of all screens. It shows the battery charge remaining, the current time,
and status icons to give an at-a-glance view of the Global Trainer ™ watch’s status.
Battery icon Shows the approximate charge of the battery. More dark
segments indicates a higher charge. The icon shows the charge
remaining while charging, plus the remaining section to charge
blinks.
t Chrono icon Appears when the chronograph is running.
d Alarm icon Appears when the alarm is set.
H Timer icon Appears when the chrono is running and a timer has been
enabled.
2:00 PM Time of Day text Current time
g Heart icon Solid: Heart rate monitor is communicating properly.
Blinking: Device is pairing or has received no useful data for
15 seconds.
RPM icon Solid: Bike speed or cadence sensor is communicating properly.
Blinking: Device is pairing or has received no useful data for
15 seconds.
Power icon Solid: Power meter is communicating properly.
Blinking: Device is pairing or has received no useful data for
15 seconds.
Satellite icon Solid: GPS has a satellite fix.
Blinking: GPS is seeking a satellite fix.
None: GPS cannot locate a satellite.
Charge Your Global Trainer ™ Watch
Before you use the Global Trainer ™ watch for the first time, the lithium-ion battery must be charged.
A depleted battery takes approximately 2 1/2 to 3 1/2 hours to fully charge.
CAUTION: The Global Trainer ™ watch should only be charged within a temperature range of 32°F - 113°F
(0°C - 45°C).
Charge Using the USB Cable
1. Insert the large USB-A plug on the download/charging clip into a USB port on any powered computer.
2. Attach the download/charging clip to the back of the Global Trainer
™ watch.
3. Make sure the four contacts on the clip touch the four metal discs on the back of the watch. Match the
red dot on the watch with the red dot on the connector for proper orientation.
4. Secure the clip to the watch caseback by placing the fixed end of the clip into the slot adjacent to the
red dot and locking the hinged end of the clip into the other slot.
Charge Using the AC Adaptor
1. Insert large USB-A plug on the download/charging clip into the USB port on the AC adaptor, and plug the
AC adaptor into an electrical outlet.
2. Attach the download/charging clip to the back of the Global Trainer ™ watch, as instructed above in steps
3 and 4.
The Power Off Function is set to SHOW TIME, so the date and time will display during charging. A blinking
battery icon appears during charging. A solid battery icon appears when charging is complete.
Use only the Phihong PSB05R-050Q power adaptor supplied with this product.
NOTE: To prevent corrosion, please dry the download/charging contacts and the surrounding area on the back
of the Global Trainer ™ watch.
Turn the Global Trainer ™ Watch On and Off
To turn the Global Trainer ™ watch on or off, press and hold 8 for 2 seconds until you hear a three-note tone.
The tone ascends in pitch when powering on, and descends in pitch when powering off.
Because the Power Off Function is set to SHOW TIME, the date and time will display when the Global Trainer ™
watch is turned off. The POWER OFF label will appear in the upper status bar.
When the Power Off Function is set to TURN OFF DISPLAY, better standby battery life is obtained. To learn
more about the Power Off Function, refer to the CONFIGURE (Mode) and the MODES sections of this USER
GUIDE.
NOTE: The display contrast can change due to temperature changes. To adjust the contrast level, follow
these steps.