Timex Global Trainer W260 - Manual (Page 23)

19
Navigate Mode Notes & Tips
• A battery save feature turns off the watch after 30 minutes of inactivity. To navigate without the watch
turning off, go to Performance Mode and activate the chronograph or answer YES to RECORD YOUR
WORKOUT DATA.
• I f you delete a waypoint, routes including that waypoint are deleted as well.
• For more accurate positioning, but with a slower refresh rate, turn the WAAS/EGNOS setting to ON in
Configure Mode. For more frequent GPS updates, but with a wider margin of error, turn the WAAS/EGNOS
setting OFF.
• The compass displays your heading and speed only when you are moving, never while stationary.
Review Mode
Use Review Mode to inspect the details of your workouts. While Performance Mode and Multisport Mode
allow you to monitor at most four workout statistics on each view screen, additional data is recorded during
your workouts, and you can view all of this data in Review Mode. You can also view the data for individual laps.
You can view the course of the workout plotted on the map as well, and track back along the workout route to
repeat the workout or to find your way back to your starting point.
Review Mode Terminology
• Workout summary: A list of all data recorded for the entire workout.
• Lap summary: A list of all data recorded for individual laps within a workout.
• Track back: Follow a saved workout either forward or backward.
View the Workout List
Press the MODE button until REVIEW appears. The list of workouts displays. Each line on the list indicates the
date of the workout, the time of the workout, and the number of laps in the workout.
The Memory Used bar at the bottom of the screen indicates how much of the workout memory is used. You
can store up to 20 workouts on the Global Trainer ™ Bodylink ® System watch, and the total number of laps in
these workouts cannot exceed 1000.
Select a Workout to View
1. Press the MODE button until REVIEW appears.
2. Press  or q to highlight the workout to view, then press 8 .
View a Workout Summary
1. Select a workout to view.
2. Press q to highlight WORKOUT SUMMARY, then press 8 .
3. Press  or q to scroll through the four data screens.
View Lap Summary Data
1. Select a workout to view.
2. Press q to highlight VIEW LAPS, then press 8 . The Laps List appears.
3. Press q to highlight the lap to view, then press 8 .
4. Press  or q to scroll through the four data screens.
The lap number appears at the top of the screen.