Timex Global Trainer W260 - Manual (Page 27)

23
Setting Group Adjustment
AUTO TIMER Select ON to take a split every time the Countdown Timer ends/repeats or at the end
of each Interval.
Alerts
Use the Alerts menu to set up visual and audible alerts in response to several conditions, including speed and
heart rate.
You can set minimum and maximum values for SPEED, HEART RATE, CADENCE, AND POWER. These values
define the target zone for the setting. If the watch detects a value outside of this zone, the alert is triggered.
Configure Alerts Type (Visual Only or Audible and Visual)
1. Press MODE until CONFIGURE displays.
2. Press q to highlight ALERTS, then press 8 .
3. Press q to highlight VISUAL ONLY or (AUDIBLE AND VISUAL).
4. Press 8 to confirm your selection.
The visual alert will display a message on top of the display for 2 seconds. It will indicate which data (speed,
heart rate, cadence, or power) is outside the target zone, and whether the reading is low or high.
If more than one reading is outside its target zone, each reading will be listed in the same alert message.
The alert message will display once every 30 seconds for as long as the reading is outside the target zone.
The audible alert tone will sound once every 30 seconds for as long as the reading is outside the target zone.
Configure Alerts Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight ALERTS, then press 8 .
3. Press q to highlight SETUP ALERTS, then press 8 .
4. Press  or q to highlight the alert to change, then press 8 to open the alert change window.
5. Press  or q to highlight a selection in the set up and press 8 to confirm your selection.
6. Repeat these steps as necessary to customize your alerts.
Settings on each Alerts submenu are detailed below.
Distance Alert
Setting Group Adjustment
DISTANCE ALERT Select ON to alert you once when the Alert At: distance is reached, REPEAT to alert
you each time the Alert At: distance is traveled, or OFF to disable the distance alert.
ALERT AT / ALERT
EVERY
Enter the distance at which to sound the alert. Press 8 to close the setting change
window. The minimum is 0.01. The maximum is 99.99.