Timex Global Trainer W260 - Manual (Page 30)

26
selection. Select NO to prevent the Global Trainer ™ watch from searching for the selected sensor or to
disconnect a sensor. Select SCAN to search for and connect a sensor.
To complete the pairing process, activate the sensor’s transmitter by wetting the pads and wearing the HRM
sensor or spinning the cranks and/or wheel for the applicable bike sensor. You can also pass the magnet
alongside an uninstalled bike sensor to generate a signal for device pairing.
When the sensor is successfully paired, an abbreviation appears in the field to the right of the sensor name:
Sensor Abbreviation
HEART RATE HR
SPEED SPD
CADENCE CAD
SPEED / CADENCE SPC
POWER METER PWR
NOTES: If you turn any of the sensors OFF, you can go back and select a previously paired sensor without
having to pair again.
You can connect only up to four ANT+ ™ sensor devices at one time. If you try to connect a fifth, the last device
connected is disconnected.
User Info
Input your personal information into the Global Trainer ™ Bodylink ® System watch to provide watch text in
your preferred language, or in determining heart rate zones, calorie expenditure, and default screens in
Performance Mode.
Language and Personal Information
To accurately measure the performance of your workouts and to assist in calculating your heart rate zones,
enter your Gender, Weight and Date of birth.
1. Press MODE until CONFIGURE appears.
2. Press q until USER INFO is highlighted, and press 8 .
3. Press  or q to select Personal and press 8 .
4. Press  or q to choose the setting group to change, then press 8 to open the setting change window.
5. Press  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Select Language
1. Press MODE until CONFIGURE displays.
2. Press q to highlight USER INFO, then press 8 .
3. Press  or q to highlight the Language displayed, then press 8 to open the setting change window.
4. Press  or q to highlight a selection, then press 8 to confirm your selection.
NOTE: If you change the language selection, the watch will go back to the initial Configure Mode display in the
revised language.