Timex Global Trainer W260 - Manual (Page 34)

30
27 X 1 3/8 2169
27 X 1 1/4 2161
27 X 1 1/8 2155
27 X 1 2145
26 X 2.125 2070
26 X 1.9 2055
26 X 1.5 1985
26 X 1.25 1953
26 X 1.0 1913
26 X 1/650 C 1952
26 X 1 3/8 2068
You can also use the “roll-out” method to measure your wheel circumference.
1. Place your front wheel on the ground with the valve stem in the 6 o’clock position.
2. Mark the position of the valve stem on the floor.
3. Roll the bike forward, keeping pressure on the handlebars, until the valve stem is again at the
6 o’clock position.
4. Mark the position of the valve stem on the floor.
5. Measure the distance between the two marks.
Power Meter
Set up how the Global Trainer ™ Bodylink ® System watch calculates and displays power meter zones.
Configure Power Meter Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight POWER METER, then press 8 .
3. Press  or q to highlight the setting to change, then press 8 to open the setting change window.
4. Press  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group Adjustment
THRESHOLD Enter the threshold power in watts. The range is 0 to 600.
VIEW Select watts or % of threshold.
ZONES Select USE THRESHOLD to automatically calculate values, or select CUSTOM to
enter ranges for the six zones.
Minimum / Maximum
Values for ZONES 1-6
Enter the minimum and maximum values for each custom zone. Press 8 to close
the setting change window. The minimum is 1. All six CUSTOM zones must appear
in ascending order and their values cannot overlap. The acceptable range is
1 - 999 watts or 1 - 100%.
GPS
Configure options for the GPS, view device version information, and view satellites. You can also reset the
watch and update the firmware from this menu.