Timex Global Trainer W260 - Manual (Page 12)

8
• The first display shows the lap number, lap time, split time, and distance.
• The second display shows the lap number, average heart rate, average pace, and average speed for
the lap.
• The third display shows the average cadence and power values from the bike sensors.
NOTE: If sensors are not connected to the Global Trainer ™ Bodylink ® System watch, their corresponding data is
not shown.
Change Views During a Workout
You can change view screens during a workout to see different performance data.
1. Start the workout as described above.
2. Press  to change view screens.
NOTE: The chronograph will continue to run, as indicated by the chrono icon on the status bar, until you
press q to stop the workout.
Stop a Workout
1. While the chronograph is running, press q. The CHRONO STOPPED message displays.
2. Hold q for 2 seconds. The SAVE WORKOUT AND RESET? Screen displays.
3. Press  or q to highlight YES, NO, or RESET ONLY, then press 8 to confirm your choice.
If you select YES, the chronograph will reset and the workout data will appear in Review mode.
If you select NO, the chronograph is not reset. Press START/SPLIT again to continue your workout.
If you select RESET ONLY, the chronograph will reset and no workout data is recorded.
Lock Performance Mode
1. Press and hold the 8 for 2 seconds.
2. A message appears confirming that the watch is locked, and a l appears in the right corner of the title
bar.
3. To unlock, hold 8 again for 2 seconds. The “WATCH UNLOCKED” message confirms deactivation. When
locked, the MODE button cannot be activated and splits cannot be taken.