Sensors, Configure sensor settings – Timex Global Trainer W260 User Manual
Page 29
25
LOW
Enter the minimum heart rate threshold. If your heart rate goes below this
threshold, the alert sounds. Press
8
to close the setting change window. The range
is 30 to 240.
HIGH
Enter the maximum heart rate threshold. If your heart rate goes above this
threshold, the alert sounds. Press
8
to close the setting change window. The range
is 30 to 240.
NOTE: If the Low value is set above the High value, the High value is automatically set to 5 beats higher than
the Low value. If the High value is set below the Low value, the Low value is automatically set to 5 beats lower
than the High value. If either value is set outside the acceptable range, the previous settings are retained.
Cadence Zone
Setting Group
Adjustment
CADENCE ZONE
Select ON to alert you when your bike crank rpm is outside the Below or Above
settings, or OFF to disable the cadence zone alert.
BELOW
Enter the minimum rpm threshold. If you go below this cadence, the alert sounds.
Press
8
to close the setting change window. The range is 0 to 200.
ABOVE
Enter the maximum rpm threshold. If you go above this cadence, the alert
sounds. Press
8
to close the setting change window. The range is 0 to 200.
Power Zone
Setting Group
Adjustment
POWER ZONE
Select ON to alert you when generating fewer or more watts than the Below or
Above settings, or OFF to disable the power zone alert.
BELOW
Enter the minimum power threshold. If you generate less power than this, the
alert sounds. Press
8
to close the setting change window. The range is 0 to 999.
ABOVE
Enter the maximum power threshold. If you generate more power than this, the
alert sounds. Press
8
to close the setting change window. The range is 0 to 999.
Sensors
Use the Sensors menu to search for, pair, and manage ANT+
™
sensor devices such as heart rate monitors,
cadence and speed sensors, and power meters.
.
Configure Sensor Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight SENSORS, then press 8 .
3. Press or q to highlight the setting to change, then press 8 to open the setting change window.
4. Press or q to highlight a selection in the setting change window, then press 8 to confirm your