Oricom ULTRA 9400 - Manual (Page 15)

13
Standby Screen
The handset displays the handset number and user name.
USER NAME
HANDSET X
Programming Functions
The system uses a menu structure to give you access to
all of the built-in features. You may program the following
items in main menu: Room Monitor, DTAM Messages and
Handset Setup.
Room Monitor (applicable only with
additional handsets)
1. Make sure your phone is OFF (not in talk mode).
2. Press the [
] button to go to the main menu.
3. Press the [ ▼ ] or [ ▲ ] button to scroll to ROOM
MONITOR.
4. Press [ ] button to enter ROOM MONITOR menu,
ROOM MONITOR EXTENSION? shows in the display.
5. Use the keypad to enter the handset number to be
monitored, either 1 or 2.
Note:
When this phone system is expanded (up to 6 handsets),
handsets are named HANDSET 1, HANDSET 2,
HANDSET 3, HANDSET 4, HANDSET 5 and HANDSET
6 respectively.
6. The receiving handset will turn on the microphone and
the originating handset will turn on the speakerphone to
monitor sound from the receiving handset.
Note:
For room monitoring mode to work, the originating
handset must NOT be on the cradle.
While in room monitoring mode, the handsets will emit
an alert tone approximately every 5 seconds if there is an
incoming call. You may press the [ ] button to quit room
monitor and answer the call.
While in room monitoring mode, the originating handset
can be switched to monitor by handset ear piece
by pressing the
[ ] button once. Switch back to
speakerphone by pressing the [ ] button once.
Press the
[ ] button on the handset to exit room
monitor mode.
HANDSET SETup