Onkyo TX-SR600 - Manual (Page 46)

46
Notes:
• You cannot select a speaker if the configuration value of the
speaker is set to “No” or “None.”
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.
To change the display of the input source from
TAPE to MD
If you connected an MD recorder to the TAPE jacks of the TX-
SR700/700E/600/600E, you can have “MD” appear when the TAPE
source button is pressed. By changing the display, when an Onkyo
MD recorder is
-connected, the system functions will become
enabled.
Changing the display:
Press and hold down the TAPE source button until the display
changes from TAPE to MD (approx. 3 seconds).
To return the display to its original setting, perform the same
procedure. This setting is necessary to allow z system functions
for a connected Onkyo cassette tape or MD recorder.
Selecting the type of audio input signal
Press the AUDIO SELECTOR button on the front panel (or AUDIO
SEL button on the remote controller) to change the audio mode.
Each time the button is pressed, the mode changes from “Auto”
→
“Multich” (only if DVD is selected as the input source)
→ “Analog”
and back to “Auto.”
Auto (automatic detection): With this setting, the TX-SR700/700E/
600/600E automatically detects whether the input signal is digital or
analog. When a digital signal is not input, then the analog signal is
played. This setting only appears if a digital input is selected for the
Digital Input setting at “Input Setup”
→ “Digital Input” (see page 53).
Multich (Multichannel): Select this setting to play back the multi-
channel input from a DVD player with a 5.1-channel input port. This
setting only appears if “Yes” is selected for the Multichannel setting
at “Input Setup”
→ “Multichannel” (see page 54).
Analog: Select this setting to play back the input from a source
component connected to analog audio input jacks. With this setting,
even if a digital signal is input from the same component, only the
analog signal will be output.
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 and
+12 decibels. Note that the calibration settings will return to the
original settings when the TX-SR700/700E/600/600E is put in
standby.
Using the remote controller:
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the LEVEL or button to adjust
the volume level.
Selecting an Audio Component
TAPE
AUDIO SELECTOR
TAP
LEVEL
AUDIO SEL
RCVR MODE
CH SEL
/
TX-SR700/700E/600/600E Remote controller