Onkyo TX-SR600 - Manual (Page 39)

39
Configuring the speakers
(1) Remember the volume level of this noise and then press the
cursor button. The TX-SR700/700E/600/600E will now emit the
pink noise from the center speaker.
(2) Using the and cursor buttons, adjust the volume level of the
noise from the center speaker so that it is at the same level as that
that was emitted from the front left speaker.
(3) Press the cursor button again. The TX-SR700/700E/600/600E
will now emit the pink noise from the front right speaker.
Use the and cursor buttons to adjust the volume of the noise
from the front left speaker so that it is the same level as that that
was emitted from the center speaker.
(4) Use the cursor button to select other speakers and adjust the
volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between –12 and
+12 decibels for all speakers in 1-decibel increments.
Press the RETURN button to return to the main menu.
Press the
MENU button on the front panel or SETUP button on the
remote controller button to exit the Setup menu.
Using the remote controller
1. Press the TEST button.
You will hear a pink noise will be emitted
from the front left speaker.
(1) Remember the volume level of this noise and then press the CH
SEL button. The TX-SR700/700E/600/600E will now emit the
pink noise from the center speaker.
(2) Using the LEVEL / buttons, adjust the volume level of the
noise from the center speaker so that it is at the same level as that
that was emitted from the front left speaker.
(3) Press the CH SEL button again. The TX-SR700/700E/600/600E
will now emit the pink noise from the front right speaker.
Use the LEVEL / buttons to adjust the volume of the noise
from the front left speaker so that it is the same level as that that
was emitted from the center speaker.
(4) Use the CH SEL button to select other speakers and adjust the
volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between –12 and
+12 decibels for all speakers in 1-decibel increments.
2. Press the TEST button to complete
the procedure.
Buttons on remote controller
Buttons on TX-
SR700/700E/600/600E
SETUP
(upper edge of
ENTER button)
(lower edge of
ENTER button)
(left edge of
ENTER button)
(right edge of
ENTER button)
ENTER
RETURN
MENU
UP
DOWN
LEFT
RIGHT
ENTER
RETURN
Displaying the Main Menu and exiting the menu
Selecting a menu or menu item
Setting the value
Selecting the menu
Returning to the previous screen
Buttons used for navigating through the menus
You can change settings in the Setup Menu using the buttons on the
front panel and on the remote controller.
The buttons on the remote controller correspond to those on the TX-
SR700/700E/600/600E as shown below.