Onkyo HT-RC180 - Manual (Page 96)

96
Advanced Setup
—Continued
Adjust Mode Mode1 (default), Mode2, Mode3
AV receiver comes with three Adjust Modes (picture setting patterns).
Picture Mode Video: Does not process in either “3:2” or “2:2” (default).
Auto: Adjusts to the picture source, automatically selecting “Picture Mode”.
3:2: Selected when the picture source is movie film, etc.
2:2: Selected when the picture source is computer graphics, animation, etc.
The AV receiver will adjust to the picture source, processing in either “3:2” or “2:2” (Picture Mode). It auto-
matically converts the source to the appropriate progressive signal and reproduces the natural quality of the
original picture.
When the “Picture Mode” setting is set to “Auto”, the AV receiver automatically detects the picture source and
in either “3:2” or “2:2”. However, there may be times when you will get a better picture by setting “Picture
Mode” yourself.
Note:
If the “Game Mode” setting is set to “On”, this setting is fixed at “Video”.
Edge Enhancement 0 (default) to +10
With this setting you can adjust the sharpness of edges in the picture. “0” is the softest. “+10” is the sharpest.
Noise Reduction Off: Noise reduction off.
Low: Low noise reduction (default).
Mid: Medium noise reduction.
High: High noise reduction.
With this setting, you can reduce noise appearing on the screen.
Note:
If the “Game Mode” setting is set to “On”, this setting is fixed at “Off”.
Brightness –50 to +50 (default: 0)
With this setting you can adjust the picture brightness. “–50” is the darkest. “+50” is the brightest.
Contrast –50 to +50 (default: 0)
With this setting you can adjust contrast. “–50” is the least. “+50” is the greatest.
Hue –20 to +20 (default: 0)
With this setting you can adjust the red/green balance. “–20” is the strongest green. “+20” is the strongest red.
Saturation –50 to +50 (default: 0)
With this setting you can adjust saturation. “–50” is the weakest color. “+50” is the strongest color.
TX-NR807_En.book Page 96 Tuesday, July 28, 2009 12:00 PM