Onkyo HT-RC180 - Manual (Page 105)

105
Advanced Setup
—Continued
Re-EQ Function
With the Re-EQ function, you can compensate a soundtrack whose high-frequency content is too harsh, making it
more suitable for home theater viewing.
Note (HT-RC180):
Re-EQ function can also be set using the [Re-EQ] button on the AV receiver.
Re-EQ Off: Re-EQ Function off (default).
On: Re-EQ Function on.
This function can be used with the following listening modes: Dolby Digital, Dolby Digital Plus,
Dolby TrueHD, Multichannel, DTS, DTS-HD High Resolution Audio, DTS-HD Master Audio, DTS Express,
DSD, Dolby EX, Dolby Pro Logic IIz Height, Dolby PLIIx Movie, Neo:6 Cinema, and 5.1-channel source +
Neo:6.
Re-EQ(THX) Off: Re-EQ (THX) Function off.
On: Re-EQ (THX) Function on (default).
This function can be used with the following listening modes: THX Cinema, THX Surround EX, and
THX Select2 Cinema.
Note:
Settings for the Re-EQ function are kept in each listening mode. However, in THX listening mode, when the
AV receiver is turned off, it will return to “On”.
Audyssey Dynamic Volume™
Dynamic Volume See “Dynamic Volume” of “Audio Adjust” on page 91.
Note:
If you would like to use Audyssey Dynamic Volume™ , when using THX listening modes, set “Loudness Plus”
setting to “Off” and set “Preserve THX Settings ” setting to “No”.
Music Optimizer
The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that use
“lossy” compression, such as MP3. The setting is stored individually for each input selector.
Note:
Music Optimizer function can also be set using the [MUSIC OPTIMIZER] button on the AV receiver.
Music Optimizer Off: Music Optimizer off (default).
On: Music Optimizer on.
Note:
The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below
48 kHz and analog audio input signals. The Music Optimizer is disabled when the Direct or Pure Audio listen-
ing mode is selected.
Speaker Levels
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV receiver is set to Standby. To save the setting you made here,
go to “Level Calibration” on page 87 before setting the AV receiver to Standby.
Subwoofer –15.0 dB to +12.0 dB (default: 0.0 dB)
Center –12.0 dB to +12.0 dB (default: 0.0 dB)
Notes:
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “Speaker Configuration” cannot be adjusted (see page 85).
• This function will not work when the Pure Audio or Direct listening mode is selected to play analog audio.
TX-NR807_En.book Page 105 Tuesday, July 28, 2009 12:00 PM