Onkyo HT-RC180 - Manual (Page 101)

101
Advanced Setup
—Continued
Notes:
• If
“ On ” is selected and the signal can be output by the TV, the AV receiver will output no sound through its
speakers.
• If “On” is selected, “TV Speaker On” appears on the Display by pressing the [DISPLAY] button.
• When
“ TV Control ” is set to “ On ” , this setting is fixed at “ Auto ” .
• With some TVs and input signals, no sound may be output even when this setting is set to “ On ” . When you
try to get audio from your TV, signals from the source component may be converted to the format supported
by your TV.
• When the “Audio TV Out” setting is set to “ On ” or “ TV Control” is set to “ On ” to hear from speakers of
-compatible TV (see page 26), by controlling the AV receiver’s volume, the AV receiver’s speakers
will produce sound while the TV’s speakers are muted. If your TV is not compatible with , the
volume level will not change. To stop the AV receiver’s speakers producing sound, change the settings,
change your TV’s settings, or turn down the AV receiver’s volume.
• When the “Audio TV Out” setting is set to “On”, the remote controller’s [AUDIO] button is disabled.
Lip Sync Disable: HDMI Lip Sync disabled (default).
Enable: HDMI Lip Sync enabled.
The AV receiver can be set to automatically correct any delay between the video and the audio, based on the
data from the connected monitor.
Notes:
• This function works only if your HDMI-compatible TV supports HDMI Lip Sync.
• You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen
(see page 93).
x.v.Color Disable: “x.v.Color” disabled (default).
Enable: “x.v.Color” enabled.
If your HDMI source and HDMI-compatible TV both support the “x.v.Color”, you can enable “x.v.Color” on
the AV receiver with this setting.
Notes:
• If the color is unnatural when “x.v.Color” is set to “Enable”, change the setting to
“Disable” .
• Refer to the connected component’s instruction manual for details.
HDMI Control (RIHD) On: enabled.
Off: disabled (default).
This function allows -compatible components connected via HDMI to be controlled with the AV
receiver.
Notes:
•
, which stands for Remote Interactive over HDMI, is the name of the system control function found
on Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Control), which
allows system control over HDMI and is part of the HDMI standard. CEC provides interoperability between
various components, however, operation with components other than
-compatible components can-
not be guaranteed.
When set to “On” and close the menu, the name of connected
-compatible components and
“RIHD On” are displayed on the AV receiver.
“Search…”
→
“(name)”
→
“RIHD On”
When the AV receiver cannot receive the name of the component, it is displayed as “Player*” or
“Recorder*”, etc (“*” means the number of two or more component).
When set to “Off” and close the menu, “RIHD Off” are displayed on the AV receiver.
“Disconnect”
→
“RIHD Off”
• Set it to “ Off ” when a connected piece of equipment is not compatible or it is unclear whether the equipment
is compatible or not.
• Set it to “Off” if the operation is not successful.
• Refer to the connected component’s instruction manual for details.
TX-NR807_En.book Page 101 Tuesday, July 28, 2009 12:00 PM