Connecting the av receiver —continued – Onkyo HT-RC180 User Manual

Page 28

■ “Monitor Out” Setting Set to “Analog”
With the “Monitor Out” setting set to “Analog”
(see page 43), video input signals flow through
the AV receiver as shown, with composite video
and S-Video sources being upconverted for the
component video output. Use this setting if you
connect the AV receiver’s COMPONENT
VIDEO MONITOR OUT to your TV.
Composite video is upconverted to S-Video and
S-Video is downconverted to composite video.
Note that these conversions only apply to the
MONITOR OUT V and S outputs, not the
VCR/DVR OUT V and S outputs.
The composite video, S-Video, and component
video outputs pass through their respective input
signals as they are.
This signal flow also applies when the “Resolu-
tion” setting is set to “Through” (see page 46).

Video Signal Flow and the Resolution Setting
When the “Monitor Out” setting is set to “Ana-
log” (see page 43), if the “Resolution” setting is
set to anything other than “Through” (see
page 46), the video signal flow will be as shown
here, with composite video and S-Video sources
being upconverted for the component video out-
put.
The composite video, S-Video, and component
video outputs pass through their respective ana-
log input signals as they are. HDMI input signals
are not output.

MONITOR OUT

DVD/BD player, etc.

AV receiver

TV, projector, etc.

Composite

S-Video

Component

Video Signal Flow Chart

HDMI