Onkyo HT-RC180 - Manual (Page 104)

104
Advanced Setup
—Continued
You can change various audio settings by pressing the [AUDIO] button.
Note:
When the “Audio TV Out” setting is set to “On”
(page 100), the [AUDIO] button is disabled.
Using the Audio Settings
AUDIO
RECEIVER
1 Press the [RECEIVER] button followed by
the [AUDIO] button.
The audio setting items appear onscreen.
2 Use the Up and Down [ ]/[ ] buttons to
select an item.
3 Use the Left and Right [ ]/[ ] buttons to
change the setting.
Repeat steps 2 and 3 for the other settings.
Tone Control Settings
You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode
is selected.
Bass –10 dB to +10 dB in 2 dB steps (default: 0 dB)
You can boost or cut low-frequency sounds output by the front speakers.
Treble –10 dB to +10 dB in 2 dB steps (default: 0 dB)
You can boost or cut high-frequency sounds output by the front speakers.
Notes:
• To bypass the bass and treble tone circuits, select the Direct, Pure Audio or THX listening mode.
• This procedure can also be performed on the AV receiver by using its [TONE], Down[
] and Up[ ] buttons
(see page 61).
Late Night Function
With the Late Night function, you can reduce the dynamic range of Dolby Digital material so that you can still hear
quiet parts even when listening at low volume levels—ideal for watching movies late at night when you don’t want
to disturb anyone.
Late Night For Dolby Digital and Dolby Digital Plus sources, the options are:
Off: Late Night function off (default).
Low: Small reduction in dynamic range.
High: Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
Auto: The Late Night function is set to “On” or “Off” automatically (default).
Off: Late Night function off.
On: Late Night function on.
Notes:
• The effect of the Late Night function depends on the material that you are playing and the intention of the
original sound designer, and with some material there will be little or no effect when you select the different
options.
• The Late Night function can be used only when the input source is Dolby Digital, Dolby Digital Plus, or
Dolby TrueHD.
• The Late Night function is set to “Off” when the AV receiver is set to Standby. For Dolby TrueHD sources,
it will be set to “Auto”.
TX-NR807_En.book Page 104 Tuesday, July 28, 2009 12:00 PM