Onkyo HT-RC180 - Manual (Page 55)

55
First Time Setup
—Continued
Using Audyssey MultEQ
®
ENTER
ON/STANDBY
Speaker setup
microphone
Notes:
• If any of your speakers is 4 ohms, change
“Speaker Impedance” setting before running
Audyssey MultEQ Room Correction and
Speaker Setup (see page 51).
• If the AV receiver is muted, it will be unmuted
automatically when Audyssey MultEQ Room
Correction and Speaker Setup starts.
• Room correction and speaker setup cannot be
performed while a pair of headphones is
connected.
• It takes about 30 minutes to complete the room
correction and speaker setup for six positions.
Total measurement time varies depending on the
number of speakers.
• Do not disconnect the speaker setup microphone
during the room correction and speaker setup,
unless you want to cancel the setup.
• Do not connect or disconnect any speakers during
the room correction and speaker setup.
• (HT-RC180) The onscreen setup menus appear
only on a TV that is connected to the HDMI
OUT. If your TV is connected to the composite
video or S-Video MONITOR OUT, or the COM-
PONENT VIDEO MONITOR OUT, use the AV
receiver’s display when changing settings.
1 Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
2 Set the speaker setup micro-
phone at the Main Listening Posi-
tion
1
(page 54), and connect it
to the SETUP MIC jack.
The speaker setting menu appears.
If you change these settings, refer to
step 5 on “Speaker Settings” (page 51)
or step 4 on “Setting the Powered
Zone 2/3” (page 118).
3 When you’ve finished, press the
[ENTER] button.
Notes:
• Before starting Audyssey MultEQ
Room Correction and Speaker Setup,
arrange the room and connect the
speakers as you would for enjoying
movies. Changes to the room after
auto setup requires you run the auto
setup again, as room EQ
characteristics may have changed.
• When starting the room correction
and speaker setup, do not stand
between the speakers and
microphone, and avoid obstacles
blocking the path between speakers
and microphone. This will produce
inaccurate results.
• Position the microphone at ear height
of a seated listener with the
microphone tip pointed directly at
the ceiling using a tripod. Do not
hold the microphone in your hand
during measurements as this will
produce inacurate results.
MultEQ: Auto Setup
Speakers Type(Front)
Powered Zone2
Powered Zone3 Normal
Not Act
Not Act
MultEQ: Auto Setup
Please place setup microphone at center of
listening area at ear height.
Next
TX-NR807_En.book Page 55 Tuesday, July 28, 2009 12:00 PM