Sylvania HDRV200F - Manual (Page 138)

130
Others
Troubleshooting (Cont’d)
Symptom Solution
P
O
W
E
R
The power does not turn on. • Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• If above solutions do not work, press RESET on the front panel
with a sharp pointed object to re-start the unit. (See page 10.)
The unit turns on automatically without
any operation. • During Auto Clock Setting, the POWER Light lights up.
• The unit turns on automatically 3 minutes before the Timer
Recording.
The power turns off automatically . • The power turns off automatically when abnormality is
detected on the disc. Press POWER or OPEN / CLOSE A
to open the disc tray, and before it is opened completely, press
the button again. Then take out the disc.
• The power turns off automatically when an OTR is completed.
• There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page
10.)
The OSD Language Setting Menu appears
every time the power turns on. • Finish up the Language Setting procedure by selecting a
language in the OSD Language Setting Menu. Press ENTER to
activate the setting.
Symptom Solution
G
E
N
E
R
A
L
The unit does not function. • or error message appears if the operation is prohibited.
• Batteries of the remote control are weak or exhausted
• There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page
10.)
Clock Setting and Channel Setting cannot
be performed. • If a Timer Recording is in standby or if a recording is in
progress, these operations cannot be performed. Delete timer
programs or stop the recording.
No picture, sound or menu appears on
the screen. • Check if the connections are made securely and correctly.
• Check if the cables are not damaged.
• Check if a correct external input channel is selected on your
TV. (See page 18.)
• Check if you have comleted the Channel Setting.
The unit does not operate properly. • Moisture has condensed inside the unit. Remove the disc and
leave the unit turned on for about two hours until the moisture
evaporates. (See page
4.)
The abnormal display appears
in the Front Panel Display. • There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page
10.)
4380_121-137.qx3 05.11.16 2:42 PM Page 130