Onkyo TX-SR605 - Manual (Page 91)

91
Controlling Other Components—Continued
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver/AV amplifier, not the component. This allows
you to control components that are out of view, in a rack,
for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
, use
the following remote control codes:
[DVD] REMOTE MODE button
0627: Onkyo DVD player without (default)
[CD/MD/CDR/DOCK] REMOTE MODE button
1817: Onkyo CD player without (default)
0868: Onkyo MD recorder without
1323: Onkyo CD recorder without
2990: Onkyo RI Dock without
Note:
If you connect an
-capable Onkyo MD recorder, CD
recorder, or RI Dock to the TAPE IN/OUT or GAME/
TV jacks, for remote operation to work properly, you
must set the input display to MD, CDR, or DOCK (see
page 51).
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Onkyo
Components Connected via
1 Make sure the Onkyo component is con-
nected with an
cable and an analog
audio cable (RCA).
See page 39 for details.
2 Enter the appropriate remote control code
for the [DVD] or [CD] REMOTE MODE but-
ton.
[DVD] REMOTE MODE button
1612: Onkyo DVD player with
[CD/MD/CDR/DOCK] REMOTE MODE button
1327: Onkyo CD player with
1808: Onkyo MD recorder with
1322: Onkyo CD recorder with
1993: Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3 Press the [DVD] or [CD] REMOTE MODE
button, point the remote controller at the
AV receiver/AV amplifier, and operate the
component.
Resetting REMOTE MODE Buttons
1 While holding down the REMOTE
MODE button that you want to
reset, press the [L NIGHT] button
for 3 seconds.
The REMOTE MODE button lights up.
2 Press the REMOTE MODE button
again.
The REMOTE MODE button flashes
twice, indicating that it’s been reset.
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers respectively. When these buttons
are reset, the preprogrammed code is
restored.
Resetting the Remote Controller
1 While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [L NIGHT] button
for 3 seconds.
The [RECEIVER] button lights up.
2 Press the [RECEIVER] REMOTE
MODE button again.
The [RECEIVER] button flashes twice,
indicating that it’s been reset.