Onkyo TX-SR605 - Manual (Page 81)

81
Advanced Setup—Continued
This section explains the items on the Miscellaneous
menu.
Volume Setup
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Volume Setup/OSD Setup
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select
“6. Miscellaneous,” and then
press [ENTER].
The Miscellaneous menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “1. Volume
Setup,” and then press [ENTER].
The Volume Setup menu appears.
6. Miscellaneous
1. Volume Setup
2. OSD Setup
6–1. Volume Setup
Maximum Volume Off
Power On Volume Last
Headphone Level 0dB
4 Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right [
]/
[ ] buttons to set them.
Maximum Volume
With this preference, you can prevent
the volume being set too high by speci-
fying a maximum volume level.
The range is from 50 to 99. To specify
no maximum volume, select Off.
Power On Volume
With this preference, you can specify
the volume setting to be used each time
the AV receiver/AV amplifier is turned
on.
The range is MIN, 1-99, MAX. To use
the same volume level that was used
when the AV receiver/AV amplifier
was turned off, select Last.
The “Power On Volume” cannot be set
higher than the “Maximum Volume”
setting.
Headphone Level
With this preference, you can specify
the headphone volume relative to the
main volume. This is useful if there’s a
volume difference between your speak-
ers and your headphones. The head-
phones level can be set from –12 dB to
+12 dB.
5 When you’ve finished, press the
[SETUP] button.
The setup menu closes.