Onkyo TX-SR605 - Manual (Page 40)

40
Turning On the AV Receiver/AV Amplifier
• Connect the AV receiver/AV amplifier’s power cord to a suitable wall outlet.
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the AV receiver/AV amplifier may cause a momentary power surge that might interfere with other elec-
trical equipment on the same circuit. If this is a problem, plug the AV receiver/AV amplifier into a different branch
circuit.
STANDBY/ON
STANDBY/ON
RECEIVER
STANDBY indicator
Connecting the Power Cord
Turning On and Standby
1 Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button, followed
by the [STANDBY/ON] button.
The AV receiver/AV amplifier comes on, the display lights up, and the STANDBY
indicator goes off.
To turn the AV receiver/AV amplifier off, press the [STANDBY/ON] button, or press
the remote controller’s [STANDBY/ON] button. The AV receiver/AV amplifier will
enter Standby mode. To prevent any loud surprises when you turn on the AV
receiver/AV amplifier, always turn down the volume before you turn it off.
or
Remote
controller
AV receiver/
AV amplifier
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver/AV amplifier before you
use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey 2EQ)” on page 41.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 48, “Component Video
Setup” on page 49, or “Digital Input Setup” on page 50 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 51.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock