Onkyo TX-SR605 - Manual (Page 86)

86
Advanced Setup—Continued
If several Onkyo components are used in the same room,
the remote controller’s control codes may overlap with
those of another component. To differentiate the remote
controller’s control codes, you can change its ID to
another number.
Note:
If you change the remote controller’s ID, be sure to set
the same ID on both the remote controller and AV
receiver/AV amplifier (see “Changing the AV Receiver/
AV Amplifier’s ID” on page 83). The default ID for both
is 1.
Changing the Remote Controller’s ID
1 Hold down the [RECEIVER] and the [CINE
FLTR] buttons at the same time.
The [RECEIVER] button lights up.
2 Use the number buttons to enter a remote
control ID.
You can enter 1, 2, or 3.
RECEIVER
CINE FLTR
Number
buttons