Onkyo TX-SR605 - Manual (Page 88)

88
Zone 2—Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver/AV
amplifier
Setting the Powered Zone 2
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Zone2,” and
then press [ENTER].
The Zone2 menu appears.
4 Use the Left and Right [ ]/[ ]
buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
nals deactivated.
Act: ZONE 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see below), the speakers connected to
the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURR BACK SPEAK-
ERS terminals do not (when Zone 2 is
activated but not used, the surround
back speakers work as normal).
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
7–2. Zone2
Powered Zone2 Not Act
5 Press the [SETUP] button.
The setup menu closes.
Using Zone 2
1 To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select AM or FM press the
[TUNER] input selector button repeat-
edly (TX-SR605 only).
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Z2 Sel: Source”
appears.
2 To turn off Zone 2, press the
ZONE 2 [OFF] button.
1 2