Raritan Computer SX - Manual (Page 137)

C HAPTER 12: C OMMAND L INE I NTERFACE 119
Command Example
admin > ports
config port 1 name ld1 bps 115000 parity odd flowcontrol
hw detect true escapemode none emulation VT100
The following command displays the current settings for port 1:
admin > Config > Port > config port 1
Port number 1:
Name: Port1
BPS: 115200
Parity: 0
Flow control: 0
RSC Terminal Emulation: VT100
Disconnect: Disabled
Application: RaritanConsole
Exit String: show strongpassword
Escape: Control-]
DPA:
IP: 0.0.0.0
Telnet Port: 0
SSH Port: 0
The following example configures DPA port settings when the Administrator chooses DPA mode
IP. The IP Address is assigned for direct port access using the following command.
admin > Config > Port > config port 1 dpaip 10.0.13.240
Port 1: Configuration Saved
DPA changes will not be available until after the SX is
rebooted.
1. The following example configures DPA port settings when the Administrator chooses DPA
mode TCPPort. The Administrator needs to set the SSH or Telnet port value assigned for
direct port access:
admin > Config > Port > config port 1 ssh 7700 telnet 8800
Port 1: Configuration Saved
DPA changes will not be available until after the SX is
rebooted.
Other DPA TCPPort options:
config
config
config
config
config