Raritan Computer SX - Manual (Page 132)

114 D OMINION SX U SER G UIDE
Configuring Network
The network menu commands are used to configure the SX network adapter.
Table 15 Configuration: Network Commands
C OMMANDS D ESCRIPTION
ethernetfailover
Enable/Disable network failover
interface
Configure the SX unit network interface.
ipfowarding IP forwarding configuration
name Network name configuration
ports Network port configuration
route Show kernel routing table
routeadd
Add route to kernel routing table
routedelete
Delete route of kernel routing table
Ethernetfailover Command
The ethernetfailover command is used to enable and disable the ability to failover from one
LAN to another.
The syntax of the ethernetfailover command is:
ethernetfailover
Interface Command
The interface command is used to configure the Dominion SX network interface. When the
command is accepted, the unit will automatically reboot and drop the connection. You must then
reconnect using the new IP address and the username admin and password newp/w entered in
the resetting factory default password section.
The syntax of the interface command is:
interface [enable ] [if ] [ip ipaddress]
[mask subnetmask] [gw ipaddress] [mode ]
The network command options are described in Table 16.
Table 16 Interface Command
C OMMAND O PTION D ESCRIPTION
enable Enable/Disable Interface
if Select LAN interface you are configuring
ip ipaddress
IP Address of the DSX assigned for access from the IP network
mask subnetmask Subnet Mask obtained from the IP administrator
gw ipaddress Gateway IP Address obtained from the IP administrator.
mode Set Ethernet Mode to auto detect or force 100Mbps full duplex
(100fdx)