Roland TD-10 - Manual (Page 89)

● Selecting the type of mike
Procedure
1. Press [STUDIO]-[F1 (MIC)].
The “MIC” page will appear.
2. Strike the pad that you wish to edit.
The setting page for the pad you struck appears.
3. Use [CURSOR] to move the cursor to “Mic Type.”
4. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Mic Type: Condenser, Dynamic 1, Dynamic 2 (KICK)
Condenser, Dynamic, Lo-Fi (SNARE)
(KICK)
Condenser: Produces the sound of a condenser mike.
Dynamic 1: Produces the sound of a standard dynamic
mike.
Dynamic 2: Produces the sound of a dynamic mike that has
the mid-to-high-range content emphasized
somewhat.
(SNARE)
Condenser: Produces the sound of a condenser mike.
Dynamic:
Produces the sound of a dynamic mike.
Lo-Fi: Emphasizes low range and is a bit “dirty.”
● Specifying the mike placement
Procedure
1. Press [STUDIO]-[F1 (MIC)].
The “MIC” page will appear.
2. Strike the pad that you wish to edit.
The setting page for the pad you struck appears.
3. Use [CURSOR] to move the cursor to “Mic Position.”
4. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Mic Position: Outside, Standard, Inside
Outside: Placed to capture more “attack.”
Standard: Standard mike location for a natural sound.
Inside:
Produces less attack and a bit more “body” of the
drum.
Settings for each group
Settings can be made for the three main instrument groups:
the drum kit,the percussion group, and the backing parts.
* The percussion group is a sound map that can be accessed when
the TD-10 is being used as a MIDI sound module. For details
refer to “Using the percussion group” (p. 126). Of course, indi-
vidual percussion sounds CAN be assigned to the pads.
■ Adjusting the amount of ambi-
ence send level for each group
The ambience can be adjusted by groups: the drum kit, the
percussion group (p. 126), and the backing part group. It’s a
convenient way to raise or lower the overall amount of
ambience without adjusting individual ambience send levels
for the instruments.
Procedure
1. Press [STUDIO]-[F4 (AMBNCE)]-[F2 (GRPSND)].
The “AMBIENCE” page will appear.
2. Use [CURSOR] to move the cursor to the group for which
you wish to make settings (“DRUMS”, “PERC”, “PART” ).
3. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Ambience Group Send: 0–127
DRUMS: Adjusts ambience send level for the entire drum
kit.
PERC: Adjusts ambience send level for the entire percus-
sion group.
PART: Adjusts ambience send level for the sequencer
parts (Part 1, Part 2, and Bass part).
Chapter 4. Studio settings
89
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10