Roland TD-10 - Manual (Page 26)

Turning on the power
Once the connections have been completed (p. 23, 24), turn on power to your various devices in the order spec-
ified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and
other devices.
fig.00-013
1 Rotate [MASTER] and [PHONES] all the way to the left to turn down the volume.
2
Turn down the volume of the connected amp or audio system.
3
Turn on the POWER switch located on the rear panel of the TD-10.
Caution when turning on the power
● After turning on the power, do not press the hi-hat control pedal (FD-7) until the drum kit
name (see the following illustration) appears in the display.
If the pedal was pressed while the power was being turned on, hi-hat open/close operations cannot be per-
formed correctly.
● After turning on the power, do not strike a pad until the drum kit name appears in the dis-
play.
Striking a pad while the power is being turned on will cause poor response when the pad is struck softly.
fig.00-037
NOTE
5
3
6
1
NOTE
Before you begin playing
26