Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E - Manual (Page 23)

( 21 / 32 )
Figure 4.5 External oscillator circuit
Figure 4.6 Circuit in which oscillation does not occur
(2) Using target system's oscillator
a. To operate the emulator with an external clock, construct the oscillation circuit shown in
Figure 4.5 in the target system and input the oscillation output at 40-60% duty into the Xin
(Xcin) pin.
b. Make note of the fact that in the oscillation circuit shown in Figure 4.6 where a resonator
is connected between the Xin (Xcin) and Xout (Xcout) pins, oscillation does not occur
because a flexible cable, buffer IC and other devices are used between the evaluation MCU
and the target system.