Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E - Manual (Page 12)

( 10 / 32 )
WARNING
Warning for Installation:
• Do not set this product in water or areas of high humidity. Make sure that the emulation pod main
unit does not get wet. Spilling water or other liquids into the emulation pod main unit can cause an
unrepairable damage.
CAUTION
Caution to be Taken for Modifying This Product:
• Do not disassemble or modify this product. Disassembling or modifying this product can cause
damage. Disassembling and modifying the product will void your warranty.
Cautions to be Taken for This Product:
• Use caution when handling the emulation pod main unit. Be careful not to apply a mechanical
shock.
• Do not touch directly the connector pins of the emulator main unit or the target MCU connector pins
with your hand.
• Do not pull the emulation pod main unit by the FLX120-RPD flexible cable or the FLX64 flexible
cable.
• The flexible cables FLX120-RPD and FLX64 are different from earlier models. The slits make
them more flexible. However, excessive flexing or force may break conductors.
• Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as used on the equipment.
Warning for Use Environment:
• The emulation pod main unit is air-cooled with the ventilation slot. Therefore, do not block the
ventilation slot. When heated to high temperatures, the emulation pod main unit may not work
properly.
• This equipment is to be used in an environment with a maximum ambient temperature of 35
°
C. Care
should be taken that this temperature is not exceeded.