Setting up, 1 removing the upper cover, Chapter 4. setting up – Renesas Emulation Pod forM16C/20 Series M30200T-RPD-E User Manual

Page 19: Caution

( 17 / 32 )

Chapter 4. Setting Up

4.1 Removing the Upper Cover

If you need to change the input frequency, remove the upper cover of the product to change the
configuration.

(1) Remove the four screws of both sides and lift off the upper cover. (see Figure 4.1)

(2) Change the input frequency following the instructions shown below.

(3) Replace the upper cover and tighten the four screws.

Figure 4.1 Removing the upper cover

Caution

Before Removing the Upper Cover:

• Always shut OFF power before removing the cover and changing the oscillator

circuit board. Removing the cover and setting switches in the power ON state could
destroy internal circuits.