Ricoh Aficio AP3200 - Manual (Page 42)

Setting Up the Printer
26
2
H
Put your fingers inside the upper
cover of the printer and remove
the cover by pulling upward.
Note
❒ The upper cover of the printer is
no longer required.
I
Remove the interchange unit cov-
er from the interchange unit.
Note
❒ The removed cover is required
in step
O.
J
Move the cable to the back of the
printer. Place the interchange unit
onto the printer as shown in the
illustration.
K
Open the upper right cover (
A A A A)
and slide the interchange unit
while keeping the cover perpen-
dicular to the printer (
B B B B). At this
time, confirm that the projection
(
C C C C) is placed in the hole securely
as shown in the illustration.
L
Fasten the two screws with fin-
gers, while keeping the upper
right cover of the interchange unit
perpendicular to the printer, and
secure the interchange unit to the
printer. Use a coin to fasten the
screws.
M
Close the upper right cover of the
interchange unit.
ZAEP650E
ZAEP500E
ZAEP700E
90
ZAEP160J
ZAEP161E
ZAEP162E