Renesas Emulation Pod M37641T2-RPD-E - Manual (Page 43)

( 41 / 68 )
4.3 Starting Up Emulator Debugger (Init Dialog Box Settings)
The Init dialog box shown in Figure 4.3 will appear after starting up the emulator debugger. Here
explains the settings in the MCU tab and Clock tab in the Init dialog box. The dialog box shown below
is an example of the emulator debugger M3T-PD38 V.5.10 Release 2. For more details, refer to the
M3T-PD38 User's Manual.
Figure 4.3 INIT dialog box
(1) Settings in the CLOCK Tab
MCU file:
To debug 7641/7643 Group MCUs,
choose the "M37640.mcu" file.
Communications interfaces:
Choose an interface you use. In this
example the serial interface is chosen.
Clock frequency:
Specify an operation clock of the target
MCU considering the frequency
division ratio of the clock.
Example:
When the supplied clock is 24 MHz
and the MCU operates divide-by-two:
Set "12" MHz.