Renesas Emulation Pod M37641T2-RPD-E - Manual (Page 26)

( 24 / 68 )
Chapter 3. Setting Up
To use this emulation pod with your application system, it is necessary to set as follows. Set the
following after removing the upper cover.
• Pins XIN and XOUT
• Pins XCIN and XCOUT
• USB-related pins (Pins Ext. Cap, D+ and D-)
• Input frequency
• Evaluation MCU
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
(1) Remove the four screws of both sides of this product and lift off the upper cover (see Figure 3.1).
(2) Set the jumper switches etc.
(3) Replace the upper cover and secure the four screws.
Figure 3.1 Removing the upper cover
CAUTION
When Removing the Upper Cover:
• Always shut OFF power when removing the upper cover and setting the switches.