P. 59, Trb tro bfr, Bfo chd cho orc – Roland FR-3x User Manual
Page 59
Treble TX/RX channel
V-Accordion
r
59
If you select “In” here, the FR-3x’s sound source can
no longer be played via its keyboards. The display
therefore shows “---” instead of a set number or reg-
ister numbers.
NOTE
See “Connecting an external MIDI device to the FR-3x” on
p. 56 for the required connection.
This parameter allows you to define the
MIDI channel for the Treble (accordion)
section. The assignment set here applies
both to the transmission (“TX”) and reception (“RX”) of
MIDI data.
MIDI data are only transmitted when “MId” (see above)
is set to “Out”, while the “RX” part is only used when
“MId” is set to “In”.
■ 1~16
Specifies the treble accordion’s MIDI channel.
■ OFF
Select “OFF” if the treble section should neither
receive nor transmit MIDI data.
NOTE
Though it is perfectly possible to assign the same MIDI chan-
nel to several sections, the result is usually disappointing and
may lead to a lot of confusion.
This parameter allows you to transpose
the Note-on messages transmitted by
the treble section up to three octaves up
or down.
This can be used for songs where an accordion register
of the Treble section (for example) should be doubled by
a piccolo flute played by an external module whose
notes would be far too low if they were used as is. As
stated above, each MIDI note has a unique number. This
parameter allows you to add (or subtract) 12 (“1”
octave), 24 (“2” octaves) or 36 (“3” octaves) to (from)
the note numbers generated by your playing.
This parameter allows you to define the
MIDI channel for the bass buttons or
Free Bass (accordion) part, depending on
which mode is currently active.
The assignment set here applies both to the transmis-
sion (“TX”) and reception (“RX”) of MIDI data.
■ 1~16
Specifies the bass or Free Bass accordion’s MIDI chan-
nel.
■ OFF
Select this setting if the bass or Free Bass section
should neither receive nor transmit MIDI data.
This parameter allows you to transpose
the Note-on messages transmitted by
the bass buttons or Free Bass section up
to three octaves up or down.
This parameter allows you to define the
MIDI channel for the chord buttons
when they are used to play the selected
accordion register.
■ 1~16
Specifies the chord part’s MIDI channel.
■ OFF
Select this setting if the chord part should neither
receive nor transmit MIDI data.
This parameter allows you to transpose
the Note-on messages transmitted by
the chord buttons up to three octaves
up or down.
This parameter allows you to set the
MIDI channel for the orchestral/organ
part.
■ 1~16
Specifies the orchestral/organ part’s MIDI channel.
■ OFF
Select this setting if the treble orchestral/organ part
should neither receive nor transmit MIDI data.
Value
1~16, OFF
Default setting: 1
Value
–3~0~3
Default setting: 0
Value
1~16, OFF
Default setting: 2
trb
trO
bFr
Value
–3~0~3
Default setting: 0
Value
1~16, OFF
Default setting: 3
Value
–3~0~3
Default setting: 0
Value
1~16, OFF
Default setting: 4
bfO
CHd
CHO
OrC
FR-3x GB.book Page 59 Thursday, March 18, 2010 6:37 PM