Roland FR-3x - Manual (Page 39)

Saving your settings (User Program)
V-Accordion r
39
Recalling a User Program
Proceed as follows to recall a User Program you saved
earlier:
1. Press the [USER PROGRAM] button.
The display now shows a “UP–” message.
The USER PRG indicator below the display lights to
indicate that the FR-3x is now in User Program mode.
2. Press the treble register ([1]~[0]) that is
assigned to the User Program whose set-
tings you want to use.
The “–” to the right of “UP” changes to the number of
the selected User Program.
3. Start playing with the new settings.
If necessary, you can select a different User Program
(see step 2 above).
4. Press the [USER PROGRAM] button again to
leave this mode.
The USER PRG indicator below the display goes dark
to indicate that the FR-3x is no longer in User Pro-
gram mode. At this point, the FR-3x returns to the
settings you were using before selecting User Pro-
gram mode, and the display once again shows the
main page.
NOTE
While the USER PROGRAM indicator below the display
lights, it is impossible to select Sets.
Editing a User Program
You can also edit existing User Programs.
1. Recall the User Program you want to edit.
See “Recalling a User Program”.
2. Press and hold the [USER PROGRAM] button
to select User Program Edit mode.
The USER PRG indicator flashes. The display shows
the main page where the numbers of the selected
registers are displayed.
3. Change the settings you want to correct.
4. Press and hold the [USER PROGRAM] button
to enter write mode.
The display now shows a flashing “UPx” message (the
“x” refers to the User Program you have been editing
thus far).
5. Do one of the following:
• To replace (overwrite) the settings of the User Pro-
gram you have been editing, press the treble register
corresponding to its number.
• To save the new version to a different User Program
memory, press the assigned treble register instead.
Your settings are saved to the selected User Program
memory.
6. Press the [USER PROGRAM] button again to
leave this mode.
The USER PRG indicator below the display goes dark
to indicate that the FR-3x is no longer in User Pro-
gram mode. At this point, the FR-3x returns to the
settings you were using before selecting User Pro-
gram mode, and the display once again shows the
main page.
NOTE
While the USER PRG indicator below the display flashes,
you can select another Set.
UP-
Lights
UP3
Flashes
FR-3x GB.book Page 39 Thursday, March 18, 2010 6:37 PM