Ricoh Type 480 - Manual (Page 46)

Sending Scan Files by Scan to Folder
38
3
Reference
For details about the maxi-
mum number of characters
that can be entered, see p.113
“Scan to Folder”.
K Press [OK].
L If entering a password to log
on is required, press [Manual In-
put]
for [Password].
The soft keyboard appears.
M Enter the password.
N Press [OK].
O To change the port number
which is set in [System Settings],
press [Change] on the right side
of the port number field. Enter
a p o r t n u m b e r u s i n g t h e
number keys, and then press
the
{{{{#}}}}key.
P Press [Connection Test].
A connection test is performed
to check whether the specified
shared folder exists.
Note
❒ The connection test may take
time.
❒ You may not be able to press
[Connection Test] right after
pressing [Cancel] during a
connection test.
Q Check the connection test re-
sult, and then press [Exit].
R Press [OK].
S To enter more destinations, re-
peat steps
A A A A to R R R R.
Note
❒ To deselect a destination, press
[
U U U UPrev.] or [T T T TNext] to display
the destination in the desti-
nation field, and then press
the
{{{{Clear/Stop}}}} key.
❒ To change the path for the
folder that has been entered,
press [Change] on the left side
of the destination field. Enter
the correct path for the fold-
er, and then press [OK].
❒ To check the selected desti-
nations, press the
{{{{Check
Modes
}}}} key.
Searching for a destination folder
in client computers on the
network
A Press [Enter Destination].
B Press [SMB].
C Press [Browse Network] on the
right side of the path field.
The list of client computers on
the same network appears.