Roland HP305 - Manual (Page 29)

31
Performing
You can play two tones simultaneously from each note of the keyboard. This feature is called “Dual Play.”
As an example, here’s how to layer piano and strings tones.
fig.Panel
1. Hold down the [Piano] button and press the [Strings] button.
Both buttons will light.
When you play the keyboard, you’ll hear both the piano and the strings tones.
About the tones
When you press any tone button, Dual play will be cancelled; you’ll hear only the tone of the button
you pressed.
You can change the pitch of tone 2 in steps of an octave (p. 57).
When you press a damper pedal while using Dual play, the effect will apply to both tone 1 and tone
2, but you may change this so that the effect applies to only one tone (p. 59).
You can change the volume balance of the two tones (p. 58).
* Dual play is not available if Split play or Twin Piano are turned on.
* For some combinations of sounds, the effect is not applied to tone 2, and this may affect how the tone sounds.
Performing with Two Layered Tones (Dual Play)
Tone name Corresponding button How to select tones
Tone 1 Left tone button Press the [-] or [+] button.
Tone 2 Right tone button
Hold down the Tone button for Tone 2 (the rightmost of the lit Tone
buttons), and press the [-] or [+] button.
HP305_302_e.book 31 ページ ２０１０年１月５日 火曜日 午後１２時２分