Runco DTV-940/943 - Manual (Page 63)

10-13
EYE-Q TM Autoconvergence
ALIGN FROM MIDPOSITION ON ALL SOURCES
When ALIGN FROM MIDPOSITION is selected, the automatic
convergence on all sources will be carried out automatically, but
starting from the midposition settings.
By projecting alternately red and blue lines, 25 convergence areas
are aligned to the green pattern. The process will repeat for as
many times as the total number of the sources until all sources are
perfectly aligned.
Follow the steps below to select:
Highlight ALIGN FROM MIDPOSITION below ON ALL
SOURCES by pushing up or down keys of the control disc;
Press the button to start up the automatic conver-
gence of the entire screen.
If the process is successfully completed, the projector will return to
image display of the current source.
Use this option when the convergence if far from proper alignment.
INTERRUPTING THE AUTOMATIC CONVERGENCE
PROCESS
The process of the above-mentioned automatic convergence can be
interrupted at any moment by pressing the button.
After the button is pressed, the projector will leave the
automatic convergence process and a message will be displayed
informing of the action:
Status: Forced
ERROR MESSAGES
The status line in the AUTOCONVERGENCE menu gives three
possible messages:
Ready: before automatic convergence starts;
Forced: when interrupting the process;
Forced break: error message.
Error messages are displayed when the automatic convergence is
not successfully completed.
EYE-Q
TOUCH UP
AUTOCONVERGENCE
QUICK AUTOPICTURE
FULL AUTOPICTURE
EYE-Q SETUP
EYE-Q DIAGNOSTICS
Select with
then .
to return or
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
ready
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
forced exit
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
ready/forced exit/forced break