Runco DTV-940/943 - Manual (Page 40)

7-7
Service Mode
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with
then
to return. or
ALL SETTINGS TO MIDPOS
All settings to midposition
Item is password protected.
Highlight ‘All settings to midposition’ with the control disc and press ENTER to
set all settings to their midposition.
A confirmation menu will be displayed first.
ENTER will set all settings to their midposition. EXIT cancel the operation to set
all settings to their midposition.
Undo all settings to midpos
When “all settings to midpos” is selected, all settings are set to their midposition.
To cancel this action, select ‘Undo all settings to midpos’ by pushing the control
disc up or down and press ENTER. ‘Undo all settings to Midposition’ is displayed
in the Memory management menu instead of ‘All settings to midposition’ when
this latter is pressed.
An undo is possible as long as the projector is playing on the same source (= same
adjustment block) even when some adjustments as geometry or convergence are
already readjusted. When undo is pressed all settings are reset to the previous set-
tings.
R & B convergence mid
Item is password protected.
Highlight ‘R & B convergence mid’ with the control disc and press ENTER to set
all convergence settings to their midposition. A confirmation screen will be dis-
played first.
ENTER sets the convergence settings to their midposition. EXIT cancels the pro-
cedure to set the convergence settings to their midposition.
ENTER displays a Confirmation screen.
EXIT returns to the Service menu.
SET TO MIDPOSITION
All settings
on current block
will be overwritten !
to confirm
to cancel
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with
then
to return. or
UNDO ALL SETTINGS TO MIDPOS
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
GR CONVERGENCE MID
Select with
then
to return. or
R & B CONVERGENCE MID
R & B CONVERGENCE MID
Convergence settings
in current block
will be overwritten !
to confirm
to cancel