Connections – Runco DTV-940/943 User Manual
Page 16
3-6
(R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) input selection
a. With the RCU: Select “Component” in the Source Selection Menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’ in chapter
‘Location and function of controls’.)
-Press ADJUST key, the General access menu is displayed on the
screen.
-Use the control disk to highlight 6.
-Press ENTER to select the highlighted source.
Connecting a computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS232 input of the projector.
The projector has a RS232 port that allows it to communicate with the VHD Controller.
The VHD Controller will communicate with the projector via its RS232 output.
This communiction includes on/off commands and source switching commands
(see the VHD Controller of this manual). This allows much easier integration
into your home theater system by only having to control a single piece of gear.
Connections
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5
6
3
4
1
2
Enter ADJUST
Select with ,
or
then
FROM LOCAL KEYPAD
RS232 IN
RS232 OUT
IR
COMM PORT
REMOTE
R
G(s)
B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
12v Fuse
Mask Screen
SOURCE SELECTION
SELECT AN INPUT
FROM BELOW:
RGB
S-VIDEO
VIDEO
COMPONENT VIDEO
Select with
or
then
FROM RCU