Runco DTV-940/943 - Manual (Page 11)

3-1
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to the wall outlet.
Plug the female power connector into the male connector on the front of the
projector.
Power Check
The power voltage is determined by the sticker on the front of the projector.
Warning!
Verify the power voltage corresponds to that of the wall outlet.
If the wall outlet voltage is different, call a qualified technician for power
adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains)
switch ON/OFF on the local keyboard
Pressed : ON
Not Pressed : OFF
Stand by indication lamp :
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Standby mode.
See installation instructions before
connecting to the supply
OFF ON
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
See installation instructions before
connecting to the supply
OFF ON
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz