Netopia 2200 - Manual (Page 267)

267
CONFIG Commands
CHAP and specify the same name and secret on the Netopia Gateway before the link can
be established.
set ppp module [vccn] port-authentication
option [ off | on | pap-only | chap-only ]
Specifying on turns both PAP and CHAP on, or you can select PAP or CHAP. Specify the
username and password when por t authentication is turned on (both CHAP and PAP,
CHAP or PAP.) Authentication must be enabled before you can enter other information.
set ppp module [vccn] port-authentication username username
The username argument is 1 – 255 alphanumeric characters. The information you enter
must match the username configured in the PPP peer's authentication database.
set ppp module [vccn] port-authentication password password
The password argument is 1 – 128 alphanumeric characters. The information you enter
must match the password used by the PPP peer.
Ethernet Port Settings
set ethernet ethernet A mode { auto | 100M-full | 100M-full-fixed |
100M-half-fixed | 10M-full-fixed | 10M-half-fixed |
100M-half | 10M-full | 10M-half }
Allows mode setting for the ethernet por t. Only suppor ted on units without a LAN switch, or
dual ethernet products (338x). In the dual ethernet case, “ethernet B” would be specified
for the WAN por t. The default is
auto.
Command Line Interface Preference Settings
You can set command line inter face preferences to customize your environment.
set preference verbose { on | off }
Specifies whether you want command help and prompting information displayed. By
default, the command line inter face verbose preference is turned off. If you turn it on, the
command line inter face displays help for a node when you navigate to that node.