Configuring for bridge mode – Netopia 2200 User Manual
Page 103
103
Configure
Configuring for Bridge Mode
1.
Browse into the Netopia Gateway’s web interface.
2.
Click on the
Configure
button in the upper Menu bar.
3.
Click on the
LAN
link.
The LAN page appears.
4.
In the box titled LAN IP Inter-
face (Ethernet 100BT):
Make note of the Ethernet IP Address and
subnet mask.
You can use this address to access the
router in the future.
5.
Click on the
Advanced
link in the left-
hand links toolbar.
6.
Under the heading of Services, click
on the
Ethernet Bridge
link.
See also other documents in the category Netopia Hardware:
- 3346(EU (2 pages)
- CLI 874 (207 pages)
- 45413 (34 pages)
- Network Adapte (19 pages)
- D3100-I IDSL (138 pages)
- 3357-02-ENT (2 pages)
- 4542 (209 pages)
- 3346-ENT (38 pages)
- Cayman 3500 Series (2 pages)
- 3386-ENT (2 pages)
- R5100 (290 pages)
- R2020 (312 pages)
- R2121 (280 pages)
- R910 (209 pages)
- 4553 (218 pages)
- Network Adapater (69 pages)
- 3347NWG-VGx (33 pages)
- 3300 (334 pages)
- 4752 (284 pages)
- 6161210-00-01 (64 pages)
- 2241N-VGX (2 pages)
- 3357W-ENT (44 pages)
- M7100 (2 pages)
- 4686-XL (2 pages)
- Firmware 4000-Series (314 pages)
- R7200 (258 pages)
- 3387W-ENT (44 pages)
- 4600 (2 pages)
- 2240N-VGX (3 pages)
- 3347-02 (2 pages)
- 3356-ENT (36 pages)
- Network Card (2 pages)
- 3-D REACH 3300 (2 pages)
- Router PN Series (301 pages)
- 4652 (45 pages)
- 4522 T1 (43 pages)
- 4622 T1 (44 pages)