Netopia 2200 - Manual (Page 249)

249
CONFIG Commands
rent dynamically-assigned IP address. This allows you to get to the IP address assigned to
your Gateway, even though your actual IP address may change as a result of a PPPoE con-
nection to the Internet.
set dynamic-dns option [ off | dyndns.org ]
set dynamic-dns ddns-host-name
myhostname .dyndns.org
set dynamic-dns ddns-user-name myusername
set dynamic-dns ddns-user-password myuserpassword
Enables or disables dynamic DNS ser vices. The default is off. If you specify dyndns.org,
you must supply your hostname, username for the ser vice, and password.
Because different dynamic DNS vendors use different proprietar y protocols, currently only
www.dyndns.org is suppor ted.
IGMP Settings
These commands are suppor ted beginning with Firmware Version 7.5.1.
set igmp snooping [ off | on ]
Enables IGMP Snooping. See “IGMP (Internet Group Management Protocol)” on page 97
for detailed explanation.
set igmp robustness value
Sets IGMP robustness range: from 2 – 255. The default is 2. See “IGMP (Internet Group
Management Protocol)” on page 97 for detailed explanation.
set igmp query-intvl value
Sets the quer y-inter val range: from 10 seconds – 600 seconds, The default is 125 sec-
onds. See
“IGMP (Internet Group Management Protocol)” on page 97 for detailed explana-
tion.
set igmp query-response-intvl value
Sets the quer y-response inter val range: from 5 deci-seconds (tenths of a second) – 255
deci-seconds. The default is 100 deci-seconds. See
“IGMP (Internet Group Management
Protocol)” on page 97 for detailed explanation.