How to set up, Vpn tunnel, Dg834g – NETGEAR ADSL MODEM WIRELESS DG834G User Manual
Page 115
Reference Manual for the ADSL Modem Wireless Router DG834G
Virtual Private Networking
8-7
v1.2, October 2006
How to Set Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
•
“Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v3” on page 8-7
uses the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
•
“Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page 8-12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G v3
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at
Figure 8-3
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
. If you have special requirements
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances” on page 8-38
to set up the VPN tunnel.
192.168.3.1
VPN Tunnel
DG834G
22.23.24.25
PC
(Running NETGEAR
ProSafe VPN Client)
PCs
0.0.0.0